Altigen MAXCS 7.0 Update 1 MultiVOIP Configuration Uživatelský manuál stáhnout pdf (Strana 21)

MAXCS 7.0 Update 1MultiVoIP Configuration Guide Page 21 of 27

Verification

At this point, you should be able pick up extension 104 and make an outbound call by dialing

914081231234.

Outpost Digits

In Figure 3, when a user makes a call to 15102520004 from extension 104, it would be nice if the system

would send the call through the MVP gateway’s FXO port channel 3 or channel 4.

To achieve this, MaxCS needs to outpost the digits “2222520004” to the gateway. To do this, MaxCS must

remove the first 4 digits of “15102520004”, and then insert “1222” to the head.

“1” of “1222” is the Location ID in the IP dialing table.

The final number sent to the gateway would be “2222520004.”

The gateway will remove the “222” from “2222520004” and then outpost “2520004” to the FXO trunk.

To configure this digit processing, follow these steps:

1. Log into MaxCS Administrator and select PBX > Out Call Routing Configuration > Route

Definition.

2. Add a new entry named Area510MVP with the following parameters:

• In the Digit Manipulation panel, check Delete from Head

• Set Number of Digits to Delete to 4

• Check Insert to Head

• Set Insert Digits to 1222

3. Set all the SIP-Tie trunks (in this example, from “04:060” to “04:071”) as Member Trunks.

4. Click Apply.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27

Žádné komentáře

Altigen MAXCS 7.0 Update 1 MultiVOIP Configuration Uživatelský manuál Strana 21